I was reading an earlier post and thought I'd try to get clarification....
Should the trans output shaft and the pinion shaft be in line (flat or zero degrees) when rear is loaded (loaded on jackstands that is as opposed to under acceleration).
Driveline Angle
-
Supershafts
- Renting Helmet
- Posts: 7
- Joined: Sun Apr 05, 2009 12:45 pm
- Contact:
Re: Driveline Angle
If you spend the time...
If you want the least amount of driveline loss....
Then you want 0 degrees under load
If you want the least amount of driveline loss....
Then you want 0 degrees under load
Long Island Motorsports Association
WE RACE, WE VOTE
http://www.limotorsports.org" onclick="window.open(this.href);return false;
]=Supershafts.com=[
WE RACE, WE VOTE
http://www.limotorsports.org" onclick="window.open(this.href);return false;
]=Supershafts.com=[