Help with sheet metal
-
Frylok
- 330ft
- Posts: 407
- Joined: Wed Mar 04, 2009 3:06 am
- Contact:
Help with sheet metal
I have a 67 chevelle that needs ALOT OF WORK.I already brought new floors for the front but Iv never done this type of work before.Whats it take to replace floor pans?I have a welder.
-
Espresso
- 60ft
- Posts: 176
- Joined: Fri Mar 21, 2008 4:29 pm
- Location: Panama City, Panama
- Contact:
Re: Help with sheet metal
This is for a '69 'velle, but the process is about the same.
http://www.tachrev.com/JeffLilly/floor_replace1.pdf
http://www.1969supersport.com/floorpn8.html
chevelles.com has A LOT of info on this.
I am currently doing the floors & trans tunnel in my Jag & it is a PITA.
This is without a doubt the hardest thing to do on any car.
http://www.tachrev.com/JeffLilly/floor_replace1.pdf
http://www.1969supersport.com/floorpn8.html
chevelles.com has A LOT of info on this.
I am currently doing the floors & trans tunnel in my Jag & it is a PITA.
This is without a doubt the hardest thing to do on any car.
-Tom