3inch Mild Steel Mandrel bends, FREE!!!!

[HonkIfPartsFallOff]

3) 180*
2) 90*
2) 45*

All 3inch OD, all uncoated mild steel, all lite surface rust from fingerprints. These were from a ProCharger intercooler install kit, i did it in aluminum tubing.


I WILL NOT SHIP!!!! Local pick up only.

[10secBu]

Sounds like a pretty good deal!

[racerlee]

where are you located?

[HonkIfPartsFallOff]

Bristol, pa.


I can bring them to cecil on May 4th

[racerlee]

that would be great!
will you pit on the spectator side again?

[HonkIfPartsFallOff]

Yes, should be same spot. You want them?

[racerlee]

Yes I do. Thanks.

[HonkIfPartsFallOff]

No problem. What's your first name? They will be in my trailer with your name on them. If you stop by and i'm not there just take them and the plastic container they are in.

[racerlee]

my names Lee. we run the green Fairmont wagon in 10.0.

[HonkIfPartsFallOff]

Ok, know exactly who you are. Any damage from that wheelstand?

[racerlee]

sorry about the late reply.
it wasn't too bad. the oil pan was scraped, the left side headers are dented, right side are scraped and the lower control arms needed repair for some bent parts. the trans oil on the track apparently came from the overflow. we are going to keep the front end tighter and see if it will stay reasonable on the launch.