Tilt steering on fox body mustang question

Anything that doesn't fit the below sections.
Post Reply
PONY GUY
330ft
Posts: 337
Joined: Fri Feb 29, 2008 9:29 pm
Location: Cape May , NJ
Contact:

Tilt steering on fox body mustang question

Post by PONY GUY »

The steering wheel on my car had a bit up and down play in the tilt function its not bad or to the point where it is falling off I was just wondering if there was a was to snug it up before it could possibly get worse
Image
mike
Pimp Status
Posts: 1789
Joined: Wed Feb 27, 2008 11:30 pm
Location: Douglassville, PA

Re: Tilt steering on fox body mustang question

Post by mike »

Yes, take off the covers on the steeing wheel, remove the turn signal assembly. Behind that are the two bolts that tighten it all up. I used some loctite and lock washers, solid as a rock.
BBC on spray...

KOP prove me wrong :)

Image
PONY GUY
330ft
Posts: 337
Joined: Fri Feb 29, 2008 9:29 pm
Location: Cape May , NJ
Contact:

Re: Tilt steering on fox body mustang question

Post by PONY GUY »

sweet tnx Mike I will get on that this weekend :mrgreen:
Image
Post Reply