89 mustang fuel gauge

[n2onotch]

cant figure out why this damn gauge is not working???? new sender put in as well.... any input??????? and the gauge lights are not working either....thanks in advance

[turbocoupejim]

did you check fuses????wires????grounds???the gauge itselft could be bad...

[rednotch]

fuel gauge amplifier aka anit slosh module on the back of the cluster or a wiring issue, if its stuck on E I would bet the circuit is shorted to ground either in the wiring or the circuit print out. I would try swaping the cluster if you can borrow one from the same year 87-89 or 90-93

[n2onotch]

i have another cluster i will have to swap in.... just have to play with it.. my car is registered collector so i have to keep the same odometer

[rednotch]

i have another cluster i will have to swap in.... just have to play with it.. my car is registered collector so i have to keep the same odometer

you can swap everything but the odometer in the clust its not hard to do..

[Mustang302]

fuel gauge amplifier aka anit slosh module on the back of the cluster or a wiring issue, if its stuck on E I would bet the circuit is shorted to ground either in the wiring or the circuit print out. I would try swaping the cluster if you can borrow one from the same year 87-89 or 90-93

not trying to jack your thread but mine doesnt work either but my cars an 86 will swapping the cluster work for 86 models too?

[PONY GUY]

fuel gauge amplifier aka anit slosh module on the back of the cluster or a wiring issue, if its stuck on E I would bet the circuit is shorted to ground either in the wiring or the circuit print out. I would try swaping the cluster if you can borrow one from the same year 87-89 or 90-93

not trying to jack your thread but mine doesnt work either but my cars an 86 will swapping the cluster work for 86 models too?

I have a 87 dash /cluster in my 86 yes it will fit

[n20capri]

A little late but check the connectors on the back of the cluster...the clips are broken off on my 86 so I have to zip tie the connector in place or my gas gauge doesn't work...

If I remember correctly my pops 87 cluster has a few missing clips and loose connectors too...