Head Gasket Recomended??

[PONY GUY]

I poped a head gasket at wildwood car show But i know know what gaskets I woudl need for a 351w bored out to a 357.
What to you guy recomend

[rednotch]

If its mild motor a set of ROL hightemps HG32841HT are cheap about 30-40 bucks and held up better then the felpo's I've used.

[PONY GUY]

Kool so do I ask for a set for a 351w or a 351w 30 over to a 357 . I have world windsor Jr heads is there a thickness they must be cause i see that there are difernt thicknesses

[adamsvega]

corteco is about the best gasket weve found .
you can get it your over bore sizes too

[stroked85olds]

cometic gaskets are awsome. but very expensive

[rednotch]

Kool so do I ask for a set for a 351w or a 351w 30 over to a 357 . I have world windsor Jr heads is there a thickness they must be cause i see that there are difernt thicknesses

'
The part number I gave ya will work fine. the gasket bore is 4.115"

.039" - HG32841HR this one is there "race" head gasket its just easior to clean up and do at the track if ya need to.
.045" - HG32841HT

I've used both and for the price ya can't beat them.

[adamsvega]

be aware of all mls /cometics gaskets they need a very smotoh head and block surface to seal well ...lotta leak issues on retro fits .
the machine surface was left rough to bite a composite gasket .
you will also need to spray em with some type of sealant as insurance!!