Anyone using Nitrous Pro-Flow's solenoid mount bracket?

[BigRedMachine]

to anyone that is using one of these plates or has knowledge of them: Im assuming you have to run a carb spacer so the linkage of the carb doesnt hit? I tried to mount it under the nitrous plate and it still hits like that too, so im assuming your running a spacer.

just looking for input

[lownslow1988]

i just put a edelbrock solenoid mount on mine under the plate and it clears all the linkages on my HP 750 DP....post up a link or pic of the one your using

[BigRedMachine]

http://www.wilsonmanifolds.com/shop/index.php?l=product_detail&p=58

I have the one that hoods 2 solenoids

[James Ratliff]

Even though I haven't use one, the edelbrock ones look about the same for half the prince in Jeg's.

I am thinking of using the aluminum ones where it has the throttle cable bracket on it as well and the other side is just the solenoid. I will attempt to attact a pic.

Edelbrock one http://www.jegs.com/i/Edelbrock/350/72287/10002/-1

Ones I like http://www.jegs.com/i/JEGS/555/15125/10002/-1 and http://www.jegs.com/i/JEGS/555/15130/10002/-1

Good luck

James

[Pyott Racing]

do you have room to mount the solenoids on under side of the bracket?

[Vajunhura]

Site section, then felt like it and use it a lot.