Need to fix the weatherstripping, when it rains hard outside, it rains hard inside in my POS blazer.
Can I take the weatherstripping off and re-seal it with that 3m weatherstrip adhesive.. or do I need brand new weatherstripping? Any place I can get it DIY or should I just go to a body shop?
thanks
My 97 blazer.. water leak drivers door
- iceman
- Pimp Status
- Posts: 2707
- Joined: Sat Mar 29, 2008 6:38 am
- Location: Maple Shade, NJ
- Contact:
-
67camaro101
- Quarter mile
- Posts: 1549
- Joined: Thu Feb 28, 2008 12:29 pm
- Location: Atco NJ
Re: My 97 blazer.. water leak drivers door
ide get the same whether stripping, go to a junkyard. be careful taking it off very small clips hold it on. if your not careful your rip it and you will be at square one again.
- iceman
- Pimp Status
- Posts: 2707
- Joined: Sat Mar 29, 2008 6:38 am
- Location: Maple Shade, NJ
- Contact:
Re: My 97 blazer.. water leak drivers door
I don't think I can make it to a u-pull-it anytime soon. Know a place that sells replacement weatherstripping?
-
Black1987stang
- Burnout Box
- Posts: 11
- Joined: Thu Dec 04, 2008 12:57 am
Re: My 97 blazer.. water leak drivers door
Weather stripping for my stang I got from I think mustangs unlimited online? but for a chevy truck they gotta have a aftermarket source or some auto parts stores can probably order you some. My car used to leak water when it rained and when I washed my car, it had worn door hinge bushings and was making the door sag and not seal against the weatherstripping, open your door and lift up on the door, if it lifts just the door up something is probably worn, and could be something else from the weatherstripping. Just a possibility
306 machined/built n tuned by me..heads/cam/intake/gears/tremec etc.4 SALE..World Products heads..Solid Roller Lifter.10/10 351W crank and rods, bearings w/ Domed Forged TRW pistons pressed on them..Bunch of GM 350 parts
- iceman
- Pimp Status
- Posts: 2707
- Joined: Sat Mar 29, 2008 6:38 am
- Location: Maple Shade, NJ
- Contact:
Re: My 97 blazer.. water leak drivers door
I took it over to Executive auto body, my man Jimmy fixed it up 


