auto to manual
-
DomOH 5 OH
- Burnout Box
- Posts: 18
- Joined: Tue Aug 25, 2009 10:14 pm
auto to manual
i just purchased a notch roller which was an auto. does anyone know what type of fabrications i need to do to get a clutch pedal installed?
-
rednotch
- 60ft
- Posts: 228
- Joined: Thu Feb 28, 2008 10:57 pm
- Location: south nj
Re: auto to manual
just need to pick up the pedals from a junk yard, they just bolt in.
Other then that you will need to inlarge the trans tunnel hole for the shifter, if you find the pedals in a yard take the spot welded sheet metal on top of the trans tunnel too so you can seal the shifter whole with a factory boot..
Other then that you will need to inlarge the trans tunnel hole for the shifter, if you find the pedals in a yard take the spot welded sheet metal on top of the trans tunnel too so you can seal the shifter whole with a factory boot..