Page 1 of 1
SBC 350 starter/flexplate questions
Posted: Sun May 23, 2010 9:58 am
by jmbracing
Is there an easy way to tell if my flexplate is on backwards? My starter pinion keeps getting stuck in the ring gear, and shims dont seem to be helping. I've tried two different starters, same thing. Its also turning the engine really slow acting like a dead battery. This is with a 225 Amp charger on it. Any ideas?
Re: SBC 350 starter/flexplate questions
Posted: Sun May 23, 2010 1:35 pm
by Frylok
did you try shimming it on just one side? Cut a shim in half and use both halfs on the inner bolt of the starter.The flexplate has raised bolts holes on it for the torque converter,make sure their facing towards the converter.
Re: SBC 350 starter/flexplate questions
Posted: Sun May 23, 2010 1:58 pm
by jmbracing
The raised part is facing the t/c. I'll try shimming one side.
Re: SBC 350 starter/flexplate questions
Posted: Wed Aug 04, 2010 6:56 pm
by 87fordgt
make sure the starter is the right gear for the flex plate there is two diffrent tooth counts for the sbc flexplate and starter combos