Page 1 of 1
454 motor and flywheel
Posted: Tue Sep 06, 2011 9:36 pm
by spot_84
looking for a 454 and a stick shift flywheel for a 454. let me know what you have. not looking for a rebuilt 5k dollar motor just a good rebuildable 454.
Re: 454 motor and flywheel
Posted: Mon Sep 12, 2011 11:48 pm
by jeffmotorman
I have 2 new 454 Mark IV bare blocks, a 4 bolt main LS7 and a 9.8" deck 2 bolt main with new flat top pistons and rings. Also have some dirty core blocks.
Jeff
215-946-0707
Re: 454 motor and flywheel
Posted: Wed Oct 05, 2011 9:22 am
by spot_84
im still looking..........would like to stay with later model bb also unless you have a real cheap early model.
Re: 454 motor and flywheel
Posted: Tue Oct 18, 2011 5:08 pm
by R/T
I have 454 engine 4 bolt mains
Engine is disassemble. Needs to be rebuilt.
Block casting # 14015445
Heads 14092360
cast crank 353039
factory rods
no intake
GM BBC iron oval port heads
Has screw in studs and guide plates. no valves and springs
3904390
$500 everything
Re: 454 motor and flywheel
Posted: Sun Dec 04, 2011 2:53 pm
by dpmalibu
There is a 78 or 79 Monte Carlo with a freshened 454 bored .030 over with a mild cam, intake etc for $2000 on Philly Craigslist. talked to guy sounds like a good deal. You could buy the car for the drive train and still sell the roller for a decent buck. The car has 24" wheels on it in pics but comes with Weld draglites. Guy's name is Morris here is the link:
http://philadelphia.craigslist.org/cto/2723127260.html
Re: 454 motor and flywheel
Posted: Sat Dec 24, 2011 8:23 pm
by hbii
i have a 454 block crank stock pistons and rods with a set of oval port heads the block needs to be bored the heads were redone with just a little time on them have jegs chrome valve covers stock timing cover and oil pan also have a stock intake will let it all go for 300