the car is an 88 lx runs great has blown trans but i have a fresh one to go with also a brand new king cobra clutch, has four pretty clean ponies on it with desent tires, has bbk shorties with catless x- pipe with pypes eliminator mufflers with 2-1/2 tail pipes, also has under drive pullies, a/c delete pulley that relocates power steering pump in it position, smog pump eliminator pulley , i have a a9l mass air comp. and the meter
the bad;
needs a hatch, rotted
needs upper rad support, car wasnt hit bad, but someone did a bad job of pulling it back out,
i'll try to have pics up tomarrow
88 mustang lx 50 5 speed with mass air 1800 obo
-
ltbnjhc
- Staged
- Posts: 36
- Joined: Sat May 17, 2008 12:47 am
-
ltbnjhc
- Staged
- Posts: 36
- Joined: Sat May 17, 2008 12:47 am
-
itslegal
- 60ft
- Posts: 88
- Joined: Thu Feb 28, 2008 3:40 pm
- Location: off exit 8a or 9 on NJTP
-
Flyin Ryan
- 60ft
- Posts: 166
- Joined: Sat Mar 15, 2008 3:43 am
- Location: NJ
Re: 88 mustang lx 50 5 speed with mass air 1800 obo
stopped by checked the car out but no one was home.. was told it was sold for 1500 guess not?
also needs front seats,door panels and rugs from what I could tell.. oh and front pas side fender will need replacing as well
also needs front seats,door panels and rugs from what I could tell.. oh and front pas side fender will need replacing as well
Last edited by Flyin Ryan on Tue May 27, 2008 10:15 am, edited 1 time in total.
-
ltbnjhc
- Staged
- Posts: 36
- Joined: Sat May 17, 2008 12:47 am
Re: 88 mustang lx 50 5 speed with mass air 1800 obo
i was [u]offered[u] 1500, and he said he would come back this week to get it, thats been the highest bid so the car stays, if he falls through then the car goes to the next guy.
the door panel is in the back seat
the door panel is in the back seat
-
NsTyFoX
- 60ft
- Posts: 87
- Joined: Sat Mar 15, 2008 12:49 pm
- Location: marlton, South jersey
-
PONY GUY
- 330ft
- Posts: 337
- Joined: Fri Feb 29, 2008 9:29 pm
- Location: Cape May , NJ
- Contact:
-
ltbnjhc
- Staged
- Posts: 36
- Joined: Sat May 17, 2008 12:47 am
