I am moving and cannot take this car with me so it must go within a few days, if not it will be parted and scrapped.
Its an '89 Notch that was a running 2.3L turbo car when I took it apart. It currently has no k member, the fenders and hood are off but I have them and the engine bay has a coat of primer on it and thats where I stopped. I dont want to sell but I am moving and wont have a garage for it.
The body is ok, the pass. side has some damage and the previous owner bondo'd it so that will need to be dealt with, its not too bad though. I do not have the front bumper because it was cracked on the bottom. Otherwise the body is ok, not rot on the floor pans just some surface rust.
The interior is stripped except for the dash and door panels they are still installed. I stripped it so I could have a roll bar installed but that has not happened in time. I will include the brand new S&W 6 point roll bar with the sale of the car. It also has a FMS 160mph speedo installed.
The engine bay still has all of the wiring for a 4 cyl car because I planned on putting a 2.3L turbo motor back in that I had built. I do not have the stock K member. There is a brand new Taylor battery box mounted in the trunk but the wiring has not been run yet for it. There is a brand new Walbro 255 high pressure fuel pump installed in the tank. Moroso cut off switch. All of the stock 4 cyl fuel lines and brake lines are still there, stock 7.5 rear, 5 spd pedals.
I am asking $500 for it.
Will need to be towed out of the garage, I will provide any help needed to the buyer loading it onto a truck or trailer. Clean title. Needs to go within a few days, if not I will strip it, sell whatever parts are left and scrap the shell.
Car is located in Ridley township Delaware County not far from the Blue Route(476) or I95. 20 minutes south of Philly airport.
Heres a link to pics: 2 pages
http://s278.photobucket.com/albums/kk109/turbolx23/
1989 Mustang Notch Roller (pics)
-
89turbo2.3
- Burnout Box
- Posts: 11
- Joined: Sat Mar 22, 2008 8:12 pm
-
white stang
- Burnout Box
- Posts: 19
- Joined: Mon Mar 31, 2008 11:35 am
Re: 1989 Mustang Notch Roller (pics)
r the seats included? any subframe connectors? can i get u r phone #?
-
89turbo2.3
- Burnout Box
- Posts: 11
- Joined: Sat Mar 22, 2008 8:12 pm
Re: 1989 Mustang Notch Roller (pics)
Car is sold.