Page 1 of 1
Relay Wiring
Posted: Wed Jul 02, 2008 7:04 pm
by moody34
I'm using a window switch that uses a ground in the rpm window to activate a nitrous relay. Has anybody activated nitrous by keeping the power lead to the relay on and the ground open? pros and cons? thanks for your help, Brian
Re: Relay Wiring
Posted: Mon Aug 04, 2008 12:41 pm
by adamsvega
you need to use the ground to trigger the relay through the w/o switch . then you can feed it volts through the relay to selnoids. and use the 2 possitives for master and arm
Re: Relay Wiring
Posted: Mon Aug 04, 2008 8:37 pm
by moody34
So arming the Window switch with the WOT switch is no good?
You think arming the WOT switch (with the ground) with the window activated from the master is a better way? thanks for the help