Page 1 of 1
purge question
Posted: Sun Aug 10, 2008 9:24 pm
by dana h
i have a fogger system and i want to put a purge system on where would i put it do i need two or one and here would it go at the y or a the noids
Re: purge question
Posted: Sun Aug 10, 2008 9:49 pm
by Pyott Racing
My purge is at my Y block Rob.Has always worked fine for me.
Re: purge question
Posted: Mon Aug 11, 2008 10:20 am
by mytmouz
IF you have solenoids for each bank you will need one for each side...
Re: purge question
Posted: Mon Aug 11, 2008 11:07 am
by mrhockey
I have my purges at the firewall right before the Y fitting. There is a very short piece of hose between there and the solenoids and there is so much pressure in the nitrous line that there is very little delay between the purge and the jets and any air is gone fast if it would be trapped. I don't think you need them on each side. That would be ideal but the guys that have 3 or 4 kits don't have 6 or 8 different purge solenoids.
Re: purge question
Posted: Thu Aug 21, 2008 4:29 am
by gmracing355
Can you guys post some pics of your setup as Im in the same boat,thanks.
Greg